RotorFlight F722 V2.2 Gyroscope Built-in ELRS Receiver - Black

Here is our set up which use with current FW on the Unit and Futaba 14SG, You can try if you want : HERE

RotorFlight 2.0 Website (for Congifurator and Tutorial): https://www.rotorflight.org/

Includes:

- RotorFlight F722 V2.2 Gyroscope Built-in ELRS Receiver x 1 set

New points compare to V2:

- Activated BEC voltage detection
- Activated 5V Bus voltage monitoring
- Optimization of motherboard and receiver lines

Configuration:

Main control: STM32F722RET6

Gyroscope: BMI270

Black Box: W25N01G (128MB)

Barometer: SPL06

Color light: WS2812

Buzzer: 5V active buzzer

USB：Type-C

Serial ports: UART2, UART3, UART5

I2C：I2C1

ADC：ADC1（12S）

Servo Channel: CH1-CH4

RPM input: RPM_E (ESC RPM line), RPM_S (RPM sensor)

Built-in receiver: ELRS dual antenna receiver 2.4G (serial port 1)

External receivers: CRSF, S.BUS, F.PORT, GHOST, SUMD, SUMH, IBUS, XBUS, XBUS/RJ01, EXBUS, PPM, MSP, DSM (with its own BEC step-down 3.3V power module)

BEC voltage: 5-15V

5V power output: 5V-1.5A

ESC protocols: PWM, ONESHOT125, ONESHOT42, MULTISHOT, BRUSHED, DSHOT150, DSHOT300, DSHOT600, PROSHOT

Disclaimer:

Rotorflight is open-sourced software, no warranty or implied as to the quality and reliability of this firmware, it is supported by the users themselves as a community.Rotorflight is under GPLv3 license. If handled incorrectly, RC models can cause serious injury or even death, and you are solely responsible for your model if you decide to use Rotorflight firmware. Any injury or damage caused by the use of Rotorflight firmware is not the responsibility of the authors of Rotorflight, the designers of RF gyroscopes, or the distributors, so please use with caution.